Table of Contents
Advertisement
n Loading sprocket-feed
paper
This is standard
computer
paper, with the holes along the
sides and perforations
between
the sheets,
It is also called
sprocket, punched,
fan-fold, or just plain "computer
paper". It
can be as narrow as 4 inches, and up to 10 inches wide (4 inches
to 15.5 inches on 15-inch type).
1. Turn
on the printer
and set the release
lever for
sprocket-feed
paper.
2. If the paper guide is installed, remove it, and put it aside
for a moment.
-
3. Place a stack of fan-fold paper behind the printer.
4. Open the sprocket covers, on the right and left sprocket
units, as shown in Figure 2-9.
Sprocket cover
1
Figure 2-9.
Open the sprocket covers to expose the sprocket
teeth.
5. Flip the clamp levers backward.
This allows the two
sprocket units to move freely right and left so you can
align them with the holes in the paper.
6. Feed the end of the paper into the slot next to the platen
cover plate.
7. Fit the holes in the paper over the sprocket pins so the
paper is even, and clamp the sprocket units in place.
Advertisement
Table of Contents
