Table of Contents
Advertisement
Select character height, width, line spaclng
Both
cESC>
1
@
CnoB
<nz>
<NuLa<NuL>
cd>
cd>
1Bh
5Bh
40h
cnO~
al>
OOh
OOh
cd>
cK?>
27
91
64
-alo>
al>
0
0
cnb
cd>
The command above is used to control character height, width and line spacing,
where cno> and cnl> (low byte first) ate used to supply the number of subsequent
data bytes (1 or 2). The effect of the two data bytes (ur2> and <n3>) is determined
as follows:
Any superscript/subscript or condensed mode print settings previously selected will
be cancelled. but if double-height printing is cancelled, the printer will return to
superscript/subscript or condensed mode printing, if these were selected previously.
Any previous commands for vertical character enlargement are cancelled by this
command. If double-height and normal-sized characters are printed in the same line,
then the printing will be aligned along the bottom of the normal-sized characters.
61
Advertisement
Table of Contents
