Table of Contents
Advertisement
Remove the top cover by lifting the front (using the two grips at the side),
and pulling towards you. Now install the ribbon.
1 Use the tensioning knob on the ribbon cartridge to tighten the ribbon if it
is slack (turn clockwise).
2 The ribbon should pass between the print head and the print head shield
(see illustration below).
,Print
head shield
3 Use the grips on the side of the ribbon cartridge to help locate the cartridge
(squeeze them inwards gently), and make sure that the spindles on the
cartridge holder fit into the sockets on the cartridge itself.
Ribbon cartridge
I
Ribbon tensioning knob
Ribbon holder
4
Advertisement
Table of Contents
