Star Micronics Multi-Font XR-1000 User Manual page 49

c.
L
h.
L
I
i.
[ Set top margin Both 1
<ESC>
C
1Bh 63h
27 99
<n>
<n>
Cn>
The command above sets the top margin, where o1> is a binary value which specifies
the height of the top margin to the first printed line in lines (at the current line pitch
setting). Printing will start on the (ol>+lth) line on the page. Subsequent changes
to the line pitch setting will not affect this value.
1 Set bottom margin Both 1
<ESC>
N <n>
I
1 1Bh 4Eh en> I
1 27 78
Cn>
I
The command abolre sets the bottom margin, where cn> is a binary value specifying
the bottom margin depth in lines at the current line pitch setting. If the page length
is reset (with the +&XX or cESC>C<NUL> commands), the effect of this
command will be lost. Subsequent changes to the line pitch setting, however, will not
affect the length set by this command.
) Cancel top and bottom margins
Both )
1 <ESC> 0
I
1Bh 4Fh
27 79
The command above cancels the settings for top and bottom margins. There are no
parameters.
Set left and right margins
<ESC> X
<n, Cn,
Both
1 1Bh 58h <II> CID
1
27
88
<to <n>
I
The command above sets the left and right margins, where the two values repre-
sented by the cnx are binary numbers used for setting the left and right margins
respectively. Margins are set at the current horizontal pitch.
d
43