Table of Contents
Advertisement
LOADING MULTI-PART FORMS
Youcan print on continuousmulti-partforms with the built-intractorunit.
Youcanusemulti-partformsthathaveupto fourpartsincludingtheoriginal
when the Multi-partmode is selectedwith the EDS setting. (For details,
pleaserefer to Chapter3.)
It is
recommended touseformsjointedby dottedorpastingunderthenormal
office condition.
Multi-part forms should be pressure sensitive, and should not be used in the
friction feed. (Bottom feed with the pull-tractor is recommended.)
NOTE:
Whenprintingcontinuousmulti-partforms,care shouldbe taken,
as the edgesof the paper mightbe damaged.
The tolerance between the dotted or pasted position and other
positionsmust be less than 0.05 mm.
18
Advertisement
Table of Contents
