Advertisement
H5AN
Installation
Terminal Arrangement
(0 V)
External
power
(Internally
supply
connected)
Unused
Power supply
For DC power
Terminal 1: –
Terminal 2: +
Connections
Power Supply Connection
Connect the required supply voltage to terminals 1 and 2.
AC Power Supply
Load Connection
Terminals 4, 5, and 6 are for contact output while terminals 12 and
13 are for solid-state output. (Terminal 14 is connected to absorb the
surge if an inductive load is connected.)
The control outputs of both contact type and solid-state type are si-
multaneously available.
8
+12 V
+12 V
Contact output
Unused
Do not use unused
terminals for relaying.
Leave them open.
DC Power Supply
Note: Specifications for 12- to 24-VDC, 48-VDC, and 100-VDC
models are listed separately in this datasheet.
Load Operation
(See note.)
Note: Output transistor ON:
Output transistor OFF: High (12 V)
When a Load Operates with Contact Output
When a Load Operates with Solid-state Output
Note: Connect a diode when using a Power Supply of 12 V or less.
H5AN
Low (0 V)
(See
note.)
Advertisement
