Spectrum
2. Click the icon for the component you wish to wink.
The Properties page appears.
3. From the General Information section of the page, view the Wink State.
If currently Off, click Wink On.
•
•
If currently On, click Wink Off.
Removing a module from the chassis
Remove the module from the chassis using a cross-head screwdriver.
1. Disconnect any cables from the module.
2. Using a screwdriver, loosen the two screws on the rear panel of the module as shown.
The screws are captive and will not come out completely.
3. Using both hands to grip the screws, gently pull out the module from the chassis, as shown in the
following figure.
Deleting an I/O module from SystemManager
Once you have removed the module from the chassis, delete the corresponding I/O module from
SystemManager.
1. Click the Diagnostics tab to display the Diagnostics page.
2. From the Device Maintenance section in the left-hand column, click the Remove Device icon to
display the Remove Device page.
3. Scroll to the I/O Modules section of the page and locate the module you wish to remove.
4. From the Select column, check the box for the I/O module you wish to remove, and then click
Remove.
A confirmation message appears.
5. Click OK.
2
12
3