Harmonic MediaCenter 2200B Quick Reference Manual

MediaCenter™ 2200B Quick Reference Guide
Front panel components
1
MediaCenter
Status LED states
File system
RAID
1 Gb Ethernet
10 Gb Ethernet
Rear panel components
1. Boot drive
2. Power button/LED
3. LTC In connector
4. 1 Gb Eth ports (1, 2 from left to right.
For system management)
5. MediaPort Ethernet array*
* Use these ports to connect to Spectrum I/O (for example, MediaPorts) only. DO NOT use these ports for any other purpose.
** If 10 Gb optical ports are installed, the onboard copper 10 Gb Ethernet ports (8.) are disabled.
Harmonic Technical Support: +888 673 4896 (Americas), +65 6542 0050 (Asia Pacific), + 44 1252 555 450 (EMEA),
+7 495 926 4608 (Russia, CIS), +81 3 5565 6737 (Japan), +86 10 8391 3313 (China, mainland)
1. Air vents
File system indicator
Off
No file system
Green
File system coming up
Dark blue (Solid) File system started, read-only
(Blink) File system present, halted
(Solid) File system started, read-write
Light blue
(Blink) File system present, unable to start
1 Gb Ethernet (system management)
Off No ports connected
Dark blue
(Solid) At least one connected port not assigned
an IP address
(Blink) Hardware or software fault
Light blue (Solid) At least one port linked at 1 Gb or more
(Blink) At least one port linked at less than 1 Gb
4
1 2 3
7
6. Serial-attached SCSI (SAS) connector
7. Redundant, hot-swappable
power supplies (0, 1 from left to right)
8. 10 Gb Ethernet ports (for file transfers)
9. VGA port (for Service only)
2
2. Power indicator 3. Status LEDs
Off
Yellow
Dark blue
Light blue
Off
Dark blue
Light blue
5
9 10 11
8
3
Raid set indicator
No RAID sets, or file system unavailable
(Solid) Rebuild(s) in proces
(Blink) One or more RAID sets unprotected
(Blink) RAID sets present, no file system
(Solid) All RAID sets protected (non-compromised)
(Blink) File system not viable to start
10 Gb Ethernet (file transfers)
No ports connected
(Solid) At least one connected port not assigned
an IP address
(Blink) Hardware or software fault
(Solid) At least one Ethernet port linked and all ports at
maximum speed (10 Gb)
(Blink) At least one port linked at less than 10 Gb
6
13
12
10. RS-232 serial (for Service only)
11. USB ports (for Service only)
12. BMC (for Service only)
13. 10 Gb optical SFP (optional,
for file transfers)**
006-0187-001 Rev. D