Table of Contents
Advertisement
5
Removal and replacement procedures for
Customer Self-Repair parts
This chapter provides removal and replacement procedures for Customer Self-Repair parts.
NOTE:
The Customer Self-Repair program is not available in all locations. Installing a part not supported by
the Customer Self-Repair program may void your warranty. Check your warranty to determine if Customer
Self-Repair is supported in your location.
Component replacement procedures
NOTE:
Details about your computer, including model, serial number, product key, and length of warranty,
are on the service tag at the bottom of your computer. See
NOTE:
HP continually improves and changes product parts. For complete and current information on
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.
There are as many as four screws that must be removed, replaced, and/or loosened when servicing Customer
Self-Repair parts. Make special note of each screw size and location during removal and replacement.
Preparation for disassembly
See
Removal and replacement procedures preliminary requirements on page 30
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
Kickstand
Table 5-1
Kickstand description and part number
Description
Kickstand
Before removing the kickstand, follow these steps:
Prepare the computer for disassembly
▲
Remove the kickstand:
1.
Lift the kickstand (1).
2.
Remove two Torx T5 1.8 × 2.5 screws from each side of the kickstand (2).
Labels on page 20
(Preparation for disassembly on page
for details.
for initial safety procedures.
L67409-001
35).
Component replacement procedures
35
Hide quick links:
Advertisement
Table of Contents
