Table of Contents
Advertisement
(13) Hall effect board cable
(14) Speaker cable
2.
On models with a SIM card installed, remove the SIM tray.
NOTE:
If a SIM blank is installed, you must remove it after removing the system board.
3.
Peel the two strips of tape off the heat sink and from near the WWAN module (1).
4.
Peel the WLAN antennas off the heat sink (2).
IMPORTANT:
Use extreme care when peeling up the WLAN antennas. Keep them as flat (not wrinkled)
as possible.
5.
Remove the three Phillips M1.0 × 1.6 screws (3).
Component replacement procedures
61
Hide quick links:
Advertisement
Table of Contents
