AT&T Partner Series Installation And Use Manual page 26

Combining Two Devices
on One Extension
You can combine a PARTNER phone of another standard device or two standard devices on one extension.
The total REN (Ringer Equivalence Number) for the devices must be 2 or less (see p. 1-3). Do not combine
two PARTNER phones on one extension jack.
Use only an AT&T 267F2 bridging adapter to combine devices (two included with each 206 module).
If the standard device's mounting cord is loose in the bridging adapter, replace the cord with an AT&T D2R
mounting cord (see appendix C).
IMPORTANT:
Follow these connection instructions instead of those included with the equipment.
1
Assemble the PARTNER phone
according to the instructions for desk
mounting (p. 2-9). Attach the mounting
cord included with the phone.
Test the PARTNER phone connection by following steps 10 and 11 on page 2-11.
Test the other device as appropriate. If it does not work correctly, see chapter 7, "Troubleshooting" or the
manufacturer's instructions.
Connecting Other Equipment
In addition to standard equipment, you can connect a variety of headsets and loudspeaker paging systems to the
system. To choose a headset or paging system to meet your needs, call your AT&T representative (or one of the
phone numbers listed on p. 1-4). Follow the instructions provided with the equipment for installation and use.
Wires in a
1pair-Plug
Green Red
D2 Type Cord
2
Assemble the other device
according to the manufacturer's instruc-
tions, except for wiring. Attach a 1-pair
mounting cord to the device (the one
included with the device or an AT&T D2R
cord).
PARTNER
Phone
or
Standard
Device
Standard Device
Only
3
Plug the mounting cord of the standard
device into the jack on the right side of the
267F2 bridging adapter. Plug the
PARTNER phone or second standard
device into the jack on the left side of the
267F2 bridging adpater (the one with four
wires). Plug the adapter into the wall jack
or an extension jack on a 206 module.
Installing the Hardware
Wall Jack
2-13