AT&T Partner Series Installation And Use Manual page 24

Insert the Button Label Sheet
7
To remove the clear plastic cover
from the phone, gently press down on
the center tab, then lift.
Test the Connection and Phone
10
To test the outside connection,
press a line button. You should hear an
outside dial tone. Repeat for all lines.
12
To test the telephone's lights and
ringer, press and hold [ # ] button for
5 seconds.
8
Place the button label sheet on
the phone. The holes on the sheet
should fit over the buttons.
11
To test the intercom, press [
You should hear a system dial tone.
13
Before releasing the [ # ] button,
lift the handset. All lights should light
and the ringer should sound. Hang up.
9
Replace the plastic cover.
If you don't hear a dial tone for step
10 or 11, see chapter 7, "Trou-
bleshooting" (p. 7-2).
].
Intercom
If the lights and/or ringer does not
respond properly, call the AT&T
Helpline at 1 800 628-2888.
Go to next page.
Installing the Hardware
2-11