Clearaudio Unify User Manual page 7

User manual / Bedienungsanleitung
Please tighten both screws when finished and re-check tracking force after adjusting VTA.
Pic. 8: Screw one for VTA Pic. 9: Screw one for VTA
10. Azimuth adjustments are facilitated through the small allen screw on the bottom side of the
armwand where the headshell enters the carbon fibre. Once you loosen this screw, you´ll be able
to rotate the headshell a small amount in either direction. Be sure to tighten the screw when done.
Pic. 10: Allen screw on the bottom side of the armwand
11. Listen to familiar recordings and make fine adjustments, as necessary, per cartridge manufactu-
rers instructions for best sound.
12. Please notice: Always move the mounted tonearm after you lift it up.
Attention:
Before the first use or after a long storage, please apply the lift unit up and down ap-
proximately 4-5 times, so that the oil inside can dissolve in order that the lift unit can
move smoothly.
Made in Germany 7