Clearaudio Unify User Manual page 6

User manual / Bedienungsanleitung
4. Slide the Clearaudio
Lock the weight in it`s position by tighten the screw in the weight. This is onlay a temporary positi-
on, the final adjustment wll be done during cartridge installation.
Turbo Weight
Pic. 5:
5. Mount your cartridge according to the manufacturer´s instructions.
6. Use the Clearaudio
to set tracking force (see cartridge instructions for recommended tracking force renge).
Adjusting tracking force is accomplished by moving the weight towards or away from the pivot point
on the shaft.
Note: When tightening the counterweight, insure that the weight is perfectly vertical otherwise this
may affect your cartridges azimuth settings.
7. Align cartridge for overhang and offset angle using the Clearaudio
(Art. No.AC005 / IEC). Once done, re-check tracking force.
8. Feed the anti-skating weight through the anti-skating support wand and secure it to the threaded
shaft at the top of the tonearm bell.
Note:
Attaching the string to the position closes to the pivot point is equal to approx.
0, 50 grams of anti-skate. Each additional 1/8" out on the shaft will give you another 0,50 grams of
anti-skating force with a maximum of 3.0 g if affixed to the end of the shaft.
Pic. 6: Placing the anti-skating weight
9. VTA adjustments are accomplished by loosening the two lock screws an the side of the armboard
base (approx. at the 10:00 and 2:00 positions). Once loosen, you can moove the arm up or down
to achieve the desired VTA.
6
Turbo Weight
on the shaft of the tonearm.
Weight Watcher
( Art. No. AC094) or the
Pic. 7: Placing the anti-skating weight
Smart Stylus gauge
Cartridge alignment gauge
Green arrowhead =
slower anti-skating
Red arrowhead =
stronger anti-skating
© clearaudio electronic GmbH, 2017/03
(Art.No. AC089)