Tire Pressure Measurement; Wheel Assembly - Club Car Onward Operator's Manual

Vehicle Maintenance
8
Maintenance Tasks
2. Lift the vehicle off of the jack stands.
3. Remove the jack stands.
4. Lower the vehicle.
5. Install the high voltage interlock fuse.
5.A Install the 10A fuse (3) into the fuse holder (1).
5.B Connect the fuse holder to the red cover (2).
Note: Removal of the high voltage interlock fuse will cause a fault code.
5.C Turn the key switch to ON, then OFF to clear the fault code.
6. Set the Run/Tow-Stow switch to RUN.

TIRE PRESSURE MEASUREMENT

Before the tire pressure measurement:
• Disable the vehicle.
To measure the tire pressure:
1. Remove the valve stem cap.
2. Use a pressure gauge to measure the tire pressure.
3. Adjust to meet the recommended tire pressure.
Note: Go to the approved wheel and tire assemblies matrix on
information regarding tire type, inflation pressure, and lug nut torque.
4. Install the valve stem cap.

WHEEL ASSEMBLY

WHEEL ASSEMBLY REMOVAL
Before the wheel assembly is removed:
• Disable the vehicle.
To remove the wheel assembly:
Page 68
http://www.clubcar.com
ONWARD HP 4-PASSENGER LITHIUM-ION
TPCC01DL00EN019 (Edition A)
for
Operators Manual