Club Car Onward Operator's Manual page 71

1. Remove the wheel cover.
2. Loosen the lug nuts.
3. Lift the vehicle to allow for removal of the wheel assembly.
4. Remove the lug nuts.
5. Remove the wheel assembly.
WHEEL ASSEMBLY INSTALLATION
Before wheel assembly installation:
• Disable the vehicle.
To install the wheel assembly:
1. Lift the vehicle to allow for installation of the wheel assembly.
2. Align the wheel assembly onto the hub of the vehicle.
Note: Make sure that the valve stem points to the outer side of the vehicle.
Note: Make sure that the tire tread is in the correct direction of travel.
3. Tighten the lug nuts until they are hand-tight.
4. Lower the vehicle.
5. Tighten the lug nuts to the recommended torque specification.
Note: Go to the approved wheel and tire assemblies matrix on
information regarding tire type, inflation pressure, and lugnut torque.
6. Install the wheel cover.
ONWARD HP 4-PASSENGER LITHIUM-ION
Operators Manual
TPCC01DL00EN019 (Edition A)
Vehicle Maintenance
Maintenance Tasks
http://www.clubcar.com
Page 69
8
for