Standard Horizon QUANTUM GX5500S Owner's Manual page 80

KEYPAD
[ 1 ( DIM )] key
When in radio mode, this key is used to directly select digit "1" in a
channel number.
Secondary use
Press the [ F ] key first then press the [ 1 ( DIM )] key to access the LCD
Dimmer menu. Refer to section "10.16 LCD DIMMER" for details.
[ 2 ( MEM )] Key
When in radio mode, this key is used to directly select digit "2" in a
channel number.
Secondary use
Press the [ F ] key first then press the [ 2 ( MEM )] key, memorize the se-
lected channel into the transceiver scan memory for scanning. When
repeat the same procedures ([ F ]
from the scan memory. Refer to section "10.13 SCANNING" for details.
[ 3 ( SCAN )] Key
When in radio mode, this key is used to directly select digit "3" in a
channel number.
Secondary use
1) Press the [ F ] key first then press the [ 3 ( SCAN )] key to start and stop
the scanning of programmed channels. Refer to section "10.13 SCAN-
NING" for details.
2) While holding down the [3 ( SCAN ) ] key and pressing the [ ] or [ ]
key, you can confirm memory channels for scanning.
[ 4 ( DW )] Key
When in radio mode, this key is used to directly select digit "4" in a
channel number.
Secondary use
Press the [ F ] key first then press the [ 4 ( DW )] key to scan for voice com-
munications on the priority channel and another selected channel until
a signal is received on either channel (Dual Watch). Refer to section
"10.12 DUAL WATCH ( TO CH-16 ) " for details.
[ 5 ( IC )] Key
When in radio mode, this key is used to directly select digit "5" in a
channel number.
Secondary use
Press the [ F ] key then press the [ 5 ( IC )] key to activate intercom function
between RAM+(s) or VH-310 handset(s). Refer to section "10.16 IN-
TERCOM OPERATION" for details.
Page 80
[ 2 ( MEM )]) , will delete the channel
GX5500S