Connection To The Mains Supply; Operation Instructions - FRIGOGLASS MV 250 P HC Manual

ENG
Figure B (Top View)
3.4

Connection to the mains supply

Connect the ICM to a 220-240 Volts power supply on a min 10A fused & grounded socket. Do not use
extension cables.
3.5

Operation instructions

The thermostat is located inside the ICM. The thermostat is factory set to approx. +4.1°C. If you
require a higher temperature (warmer), turn the thermostat knob anticlockwise. If you require a lower
temperature (colder), turn the thermostat knob clockwise.
12
8. Pin & screw the bottom hinge to the
9. Position the new top hinge (e - which is
10. Screw the door handle to holes.
11. Insert the plugs (d) to the idle holes.
Do not connect the merchandiser to:

a non grounded wall socket or power line

improper supply voltage and frequency

power supply that does not comply with the safety regulations of
the appliance or with current legislation on electrical installations

Do not plug the cooler into a multiple outlet strip or use
extension cables.

If the supply cord is damaged, it must be replaced by the
manufacturer, its service provider or similarly qualified person.

Route the power cables in such a way that they are protected
from damage and they do not pose a risk of tripping.
Do not use electrical appliances inside the storage compartments of the
appliance, unless recommended by the manufacturer.
Do not use the merchandiser to store unpacked food.
bottom left
supplied inside the appliance) as shown in
Figure-B, after pinning it; rotate counter-
clockwise to its place, then screw. This is
required to assure self-closing of the door