Connection To The Mains Supply; Maintenance - FRIGOGLASS Impulse Chest Cooler User Manual

If the supply cord is damaged, it must be replaced by the
manufacturer, its service provider or similarly qualified
persons in order to avoid a hazard.
c. The merchandiser must stand upright for at least 1 hour after transportation and
prior to start up.
d. Ensure that there is a spacer to maintain a distance between the back side of the
ICM and the wall, and that nothing is placed on top of the ICM.
Do not use electrical appliances inside the cooler.
e. Allow a minimum gap of 100mm at the rear and 50mm at the sides of the cooler.
Assemble the spacer supplied with the appliance to adjust the correct distance
from the rear walls. Do not place anything on top of the ICM.

3.2 Connection to the mains supply

Connect the ICM to a 120 Volts, 60Hz power supply on a min 10A fused & grounded
socket. Do not use extension cables. If the power cord is not long enough, ask an
authorized electrician to replace it with a longer one, or to install a socket near the
ICM.
Do not compress the main cable.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service provider or similarly qualified
persons in order to avoid a hazard.

4. Maintenance

PRIOR TO ANY CLEANING OR MAINTENANCE PROCEDURE,
UNPLUG THE ICM!
DO NOT DAMAGE THE REFRIGERANT CIRCUIT.
ENG