Adjusting The Shelf (Not Applicable To Units With Plastic Inner Liner); Switching The Door Opening Direction (Only For Applicable Models) - FRIGOGLASS MV 250 P HC Manual

Mains connection: If the mains cord supplied is not long enough, do not use an extension lead and do
not replace it. Ask an authorized electrician to replace the cord with a longer one.
3. The merchandiser must stand upright for at least 1 hour after transportation and prior to start-up.
This gives the oil time to run back to the compressor after transit and installation.
4. Allow a minimum gap of 100mm at the top, 100mm at the rear and 50mm at the sides of the
cooler for proper ventilation. Do not place anything on top of the cooler.
3.2

Adjusting the shelf (not applicable to units with plastic inner liner)

To adjust the shelf first unload it, lift it and unclip the shelf clips (4). Place the clips in the desired
position and reposition the shelf. Make sure that the horizontal metal rods at the bottom of the shelf
are between the front and back shelf clips.
3.3

Switching the door opening direction (only for applicable models)

Figure A
Keep the ventilation openings, both in the appliance enclosure and in the
built-in structure, clear of obstruction.
Please follow the instructions for changing
door opening directions below
1. Unplug the cooler
2. Lay the cooler on its back
3. Unscrew the door handle (a)
4. Remove plugs from the holes (d)
5. Unscrew the top & bottom hinges (b & c)
6. Remove the door
7. Turn the 180° door as shown with arrows
ENG
11