Introduction; Measurements And Standards Used; Safety Instructions - Xylem MJK pHix Compact Manual

Introduction

Thank you for choosing a pHix® Compact pH / Redox transmitter.
We have done everything possible to make a pH / Redox transmitter that can
fulfill all your demands.
pHix® Compact is very simple to install and connect, as electrode, fitting and
transmitter is built together in the same NEMA 6X class enclosure. By doing
so, all error sources like e.g. bad cable connections and leaking fittings are
eliminated.
As pHix® Compact is equipped with an union flange in one end and male
thread in the other, the transmitter is very easily mounted in open tanks as
well as pipes without the usual use of fittings.
You can always contact your representative or the MJK Service Hotline for
advice and guidance. Also, take a look at
pHix® Compact is registered trademark of MJK.

Measurements and standards used

This manual uses the metric measurement system, Celsius and European
industry standards where applicable.

Safety instructions

1. Read this manual carefully.
2. Be aware of the environment on the installation site. Wear necessary
protective equipment and follow all current safety regulations.
3. pHix® Compact can provide a start signal for dangerous machinery.
Always ensure that connected machinery and other equipment are
effectively being put out of service (i.e. removal of main fuses, lock main-
and/or security switches in off position) before commencing setting, fault
finding, service and maintenance work etc.
www.mjk.com
6
MANUAL
EN 4.10 pHix® Compact 1904