Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kontron DIMM-PC ADA7
Summary of Contents for Kontron DIMM-PC ADA7
- Page 1 Kontron User's Guide ® DIMM-PC ADA7 ® Document Revision 125...
- Page 2 This page intentionally left blank...
- Page 3 Table of Contents Table of Contents User Information ......................4 About This Manual .....................4 Copyright Notice ....................4 Trademarks ......................4 Standards ......................4 Warranty ......................4 Technical Support ....................5 Kontron User's Guide DIMM-PC ADA7...
-
Page 4: User Information
“as-is” and is subject to change without notice. For the circuits, descriptions and tables indicated, Kontron assumes no responsibility as far as patents or other rights of third parties are concerned. - Page 5 Kontron Embedded Modules GmbH will not be responsible for any defects or damages to other products not supplied by Kontron Embedded Modules GmbH that are caused by a faulty Kontron Embedded Modules GmbH product.
-
Page 6: Connector Location
I/O Modules POTI (for Dot Matrix Disp.) COM4 Ethernet (from I/O Module) JIPA Link / Activity Display Con. LEDs for Ethernet Backlight Speaker Note: On every through-hole connector, Pin1 is marked with a quadratic pad! Kontron User's Guide DIMM-PC ADA7... -
Page 7: Connector Pinout
BUSY# IRQ6 FDCWDAT# IRQ5 IOW# /IOW IRQ4 FDCWG# IRQ3 IOR# /IOR SLCT# DACK2# FDCTRK0# IOCHRDY IOCHRDY BALE FDCWPRT# FDCRDATA# IRQ14 IRQ15 IOCS16# IOCS16# FDCHDSEL# DSKCHG IDE CS0# S_IDE CS0# IDE CS1# S_IDE CS1# HDLED# S_HDLED# Kontron User's Guide DIMM-PC ADA7... - Page 8 SD14 SD15 S IDECS1# IOR# IOW# MAD12 IRQ15 MAD13 MAD14 MS SELECT MAD15 RSTDRV# IOCHRDY I2DAT I2CLK SD10 DA O0 VDCLK VSYNC HSYNC BLUE GREEN SW BACK VDD SRC BACK SRC +12V +12V FPVEE VPANEL Kontron User's Guide DIMM-PC ADA7...
- Page 9 To protect the external power lines of peripheral devices the customer has to take care that: the wires have the right diameter to withstand the maximum available current ® the enclosure of the peripheral device fulfils the fire protecting requirements of ® IEC/EN 60950. Kontron User's Guide DIMM-PC ADA7...
- Page 10 Two mounting holes for banana plug connectors (+5V and GND) ® LPT port (25pos. DSUB Connector) ® Four serial ports (9pos. DSUB Connector): ® 3 x RS232-ports (COM1, COM2, COM3); 1 x RS485-port (COM4) ® 15pos. VGA-header DSUB ® Kontron User's Guide DIMM-PC ADA7...
-
Page 11: Dot-Matrix-Display
Note: You can‘t use the DOT-matrix display and a printer at the same time. If you want to use a printer please enter setup again and change the settings for the LPT port into “normal“. Now the DOT-matrix display has no function. Kontron User's Guide DIMM-PC ADA7... - Page 12 • that the enclosure of the peripheral device fulfils the fire protecting requirements of IEC/EN 60950. Battery voltage for RTC: 3.0 ... 4.2 V Battery supply current: max. 10 μA Kontron User's Guide DIMM-PC ADA7...
-
Page 13: Battery Information
English, German, French, Danish, Finish and Spanish language. If the battery of this product however is accessible by the end user, it is in the responsibility of the Kontron customer to give the corresponding safety instructions in the required language(s). -
Page 14: Document History
05.04.02 ADA7K120.DOC J. Baumgartner All infos according to HW Rev. 2.x 24.06.02 ADA7k121.DOC J. Baumgartner security infos added, references to USB removed Changed to Kontron logo. Added battery information 11.12.03 ADA7k122.DOC D. Gunter section. 08.02.07 ADA7K123.DOC T. Schertel Removed X18, Correct title 03.04.07...
Need help?
Do you have a question about the DIMM-PC ADA7 and is the answer not in the manual?
Questions and answers