Fujitsu Siemens Computers PRIMESTATION Series Manual page 62

Configuration
Modifying the RCA configuration
Changes can be made to the RCA configuration using the xscon command:
Syntax:
<RCA AdministrationAccess>
xscon
RCA administration access
The administration access to the RCA4 created under mkrca or explicitly
using mklancon is referred to in general as <RCA SystemName >adm.
The user name Admin should be used for logging on to the RCA.
The main commands for configuring the RCA are listed in the section "RCA
commands". The RCA command HELP provides an initial overview.
If you are using the LAN Console on an RM system, the line speed for the
connected RCA port should be set to 19200 baud in the RCA setup, see "Port
commands".
RCA firmware updates
New firmware versions for the RCA4 are available under
http://service.fujitsu-siemens.com/support/primestation/RCA4.
Additional installation information is also provided here for every firmware
version and must be observed.
The firmware is updated via an TFTP server (Solaris system). The update is
executed via the administration access to the RCA - see above - by means of
the RCA command
server flash boot|app hostip=<
image=<Name of Image
See "RCA commands" on page 75
Removing a LAN Console
Ê Remove all configuration entries, for example using
rmlancon -a
Access can be cancelled for the RCA4 using the
RCA SystemName
arp -d <
command.
Ê Uninstall all software packages of the LAN Console software product.
56
PRIMESTATION as LAN Console
Adresse TFTP-Server>
>
>
U41270-J-Z916-2-76