Fujitsu Siemens Computers PRIMESTATION Series Manual page 54

Configuration
The RCA is configured in three stages:
– The configuration data, i. e. /IP and MAC address, system name is recorded.
– The mkrca script is invoked in order to make the RCA known in the network.
– The RCA is switched on.
– The configuration data is set in the RCA.
Recording the configuration data
SMAWxsco provides the template file /opt/SMAW/SMAWxsco/misc/setup.tpl for
recording the configuration data, IP and MAC address and the name of the
RCA. Because both the RCA3 and RCA4 can be configured with the current
software, this file contains all of the data for the RCA3 in addition to the infor-
mation relevant for the RCA4.
I
The configuration of an RCA3 is described in the previous version of this
manual (LAN Console, Order Number U41224-J-Z916-1-76).
Ê Copy this file to any work file.
V
Do not modify the template file
The template file itself should not be modified so that it is available to
configure other RCAs.
Ê Now fill in the work file using an editor.
You will need to refer here to the information provided about the network and
RCA at the start of the section "Commands" on page 44.
The content of the work file - as described in Template file
/opt/SMAW/SMAWxsco/misc/setup.tpl - is analyzed by a shell and loaded,
i.e. the entries must comply with the shell syntax rules (e.g. values must
follow straight after the "=" character). Syntax and/or plausibility errors are
reported and cause the respective script to terminate.
I
As usual in the shell, comments are indicated by a preceding "#".
Template file /opt/SMAW/SMAWxsco/misc/setup.tpl
# Configuration Template for RCAs setup.ini
#
# fill in like:
# ethernet address:
#
# ip address:
48
KEY=value
6 2-digit hex values separated by a
colon (00 - FF)
4 numeric values separated by a dot
PRIMESTATION as LAN Console
U41270-J-Z916-2-76