Setup; Assembling The Handle - Toro HoverPro 400 Operator's Manual

Setup

Note:
Determine right and left side of the machine
from normal operating position.
1

Assembling the Handle

No Parts Required
Procedure
1. Slide the lower handle into the frame
1. Footstop
2. Hairpin
3. Bolt
2. Secure each side with a retaining pin and a
hairpin (Figure 3).
3. Secure the footstop to the right side of the lower
handle using an M6 nut, and M6 bolt, and 2
washers (Figure
4. Attach the footstop to the frame with a retaining
pin and a hairpin
5. Connect the upper handle to the lower handle by
securing each side with a U-bolt, an M6 washer,
and a handwheel
(Figure
Figure 3
4. Retaining pin
5. Washer
6. Locknut
3).
(Figure 3).
(Figure 4).
3).
1. Upper handle
2. Hand wheel
3. Washer
g017374
5
Figure 4
4. U-bolt
5. Lower handle
g017373