Replacing The Cutting Line; Cleaning The Machine - Toro HoverPro 400 Operator's Manual

Replacing the Cutting Line

Service Interval: Yearly
1. Turn the fuel valve to the O
the vent knob.
2. Disconnect the wire from the spark plug.
3. Turn the machine on its side, with the dipstick
facing down.
4. Wearing protective gloves, remove the nylon
cutting line.
5. Place 1 length of nylon cutting line into the
desired cutting-height setting. Ensure that a
second line of the same length is placed in the
corresponding cutting height on the opposite
side of the cutting disc.
Note:
If using a spare reel, cut the line to a length
of 20 cm (7-7/8 inches).
position and close
FF
17

Cleaning the Machine

Service Interval: After each use
WARNING
The machine may dislodge material from
under the machine housing.
• Wear eye protection.
• Stay in the operating position (behind the
handle).
• Do not allow bystanders in the area.
1. Tip the machine on its side, with the dipstick
down.
2. Use a brush or compressed air to remove grass
and debris from the exhaust guard, the top cowl,
and the surrounding deck areas.