Operating Tips; After Operation; After Operation Safety - Toro HoverPro 400 Operator's Manual

Operating Tips

General Mowing Tips
Important:
Operating the machine on slopes of
more than 25° will cause severe engine damage
due to a lack of lubrication. Do not operate the
machine on slopes greater than 25°.
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
•
Avoid striking solid objects with the cutting line.
Never deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately shut off the engine, disconnect
the wire from the spark plug, and examine the
machine for damage.
•
For best performance, install new cutting lines
before the cutting season begins.
•
Replace the cutting line when necessary with Toro
replacement cutting line.
•
Ensure that the replacement cutting line is the
same length as the intact cutting line.
Cutting Grass
•
Cut only about a third of the grass blade at a time.
Do not cut below the highest setting (30 mm or 1.2
inches) unless the grass is sparse or it is late fall
when grass growth begins to slow down. Refer to
Adjusting the Cutting Height (page
•
Mowing grass over 15 cm (6 inches) in length is
not recommended. If the grass is too long, the
machine may plug and cause the engine to stall.
•
Wet grass and leaves tend to clump on the yard
and can cause the machine to plug or the engine
to stall. Avoid mowing in wet conditions.
•
Be aware of a potential fire hazard in very dry
conditions, follow all local fire warnings, and keep
the machine free of dry grass and leaf debris.
•
If the finished lawn appearance is unsatisfactory,
try 1 or more of the following:
– Inspect the underside of the cutting unit for
worn or damaged components (e.g., the cutting
line) and repair or replace them if necessary.
– Walk at a slower pace while mowing.
– Raise the cutting height on your machine.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full
swath with each pass.
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need
to make more than a single pass over the leaves.
•
Mowing grass over 15 cm (6 inches) in length is
not recommended. If the leaf cover is too thick, the
machine may plug and cause the engine to stall.
•
Slow down your mowing speed if the machine
does not cut the leaves finely enough.

After Operation

After Operation Safety

General Safety
•
Always shut off the machine, wait for all moving
parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
•
Secure the machine.
9). •
Use care when loading and unloading the
machine.
13