Maintenance Work; Engine Oil Change - Man E3268 LE212 Operating Instructions Manual

8.4 Maintenance work

8.4.1

Engine oil change

WARNING
Risk of injury due to hot oil
Engine oil gets hot during operation and causes scalding if touched.
For this reason:
S Only touch the oil drain screws using protective gloves.
User tip
Use a container with a capacity of at least 100 litres for the oil change.
User tip
Replace the oil filter inserts each time the engine oil is changed.
Drain engine oil
Drain engine oil with engine at operating temperature.
1. Loosen the oil filter cover
2-3 turns.
The engine oil then flows out of the oil module into
the oil pan.
3. Position the container below the oil drain plug
2 .
4. Unscrew the oil drain plug
and allow all the oil to drain.
5. Screw the oil drain plug
sealing ring and tighten it.
Tightening torque . . . . . . . . . . . . . . . . . . . . .
Carefully read these Operating Instructions before starting any work!
This is especially valid for the chapter on General Safety Instructions
and the safety instructions in each of the chapters.
1
and unscrew by
2
at the oil pan
2 back in with a new
80 Nm
Maintenance and Care
75