Advertisement
4.2.8 - "TS settings" page
In this section (Figure 12), the user is able to setup all the TS settings of the four multiplex in
HCL-804CT's output.
For each multiplex output the user can setup the following settings:
TS ID: Which is the ID No of the specific multiplex (1...65535)
Net ID: Which is the Net ID No of the specific multiplex (1...65535)
Original Net ID: Which is the Org. Net ID No of the specific multiplex (1...65535)
Network Name: Which is the network name of the specific multiplex
LCN provider: Choose the appropriate LCN provider (EACEM, ITC, Nordig, APN)
System
4.2.9 - "LAN" page
In "LAN" page (Figure No 13) the user is able to setup all the parameters of the LAN control
of the device as follows:
DHCP – Enable or disable DHCP
IP address: Set a static IP address for controlling the device
Subnet mask: Set the specific Subnet mask
Gateway: Set the gateway's IP address
Primary DNS: Set the IP address of the primary DNS
Secondary DNS: Set the IP address of the secondary DNS
Port: Assign the control port
Lemco
HCL-804CT manual v1.0
Figure No 12
16
Advertisement
