With the use of the radio buttons the user is able to select the mode that the HCL-804CT will
operate as follows:
DVB-T: 4 x modulator working in DVB-T standard + IP streaming
DVB-C: 4 x modulator working in DVB-C standard + IP streaming
IP only: All modulators are disabled, the device does IP streaming only
For each modulator in DVB-T mode the user is able to setup the following parameters:
Frequency – The output frequency of the first modulator*
Constellation – The constellation of the first modulator*
Code Rate – The coder rate of the first modulator*
Guard Interval - The guard interval of the first modulator*
Channel Bandwidth – The channel bandwidth of the first modulator*
Modulation – The modulation type of the first modulator*
Enable/Disable – Enable or disable the current modulator
Output level – Adjust the output level for each modulator from 70-90dΒμV.
Lemco
HCL-804CT manual v1.0
Figure No 8
13