Advertisement
In Figure No 10 we have general settings of the IP streamer as follows:
IP address: This is the IP address of the streamer for ping purposes.
MAC address: This is the MAC address of the streamer
IGMP: The user is able to select IGMP v2 or v3 or disable the IGMP.
The Status section provides a general view of how many programs and in what format are
currently being streamed from the device is its four outputs.
In order to setup the IP address for each program there are four tabs one for each IP output of
the HCL-804CT.
By selecting e.g. the TS1 tab (Figure No 11) the user is able to setup the IP streamer for this
specific output, following the steps below:
st
1
step: Select SPTS or MPTS streaming mode.
SPTS mode: Means that each program has its own IP
MPTS mode: Means that all the programs of the current output (e.g. TS1) will be
streamed in a single IP.
2nd step: For each program (in SPTS mode) or for the whole TS (in MPTS mode) the user is
able to assign a multicast IP address from 224.0.0.0 to 239.255.255.255 or a unicast
IP address as well as its destination port and protocol (UDP or RTP).
By repeating the above procedure for all four outputs of the HCL-804CT, the user is able to
setup the IP streamer of the device.
Lemco
HCL-804CT manual v1.0
Figure No 11
15
Advertisement
