Advertisement
* All the four outputs of the HCL-804CT operate in adjacent RF output channels. This means
that the user setups only the first modulator and all the other three modulators have the same
settings and automatically are being program in adjacent channels.
E.g. If the user sets the CH21 in UHF band on modulator No1 the other three modulators will
be automatically set to CH22, CH23 and CH24, respectively.
Figure No 9
The status section in (Figure No 9) provides a general idea to the user of the current payload
(according to the selected programs) comparing to the max. output payload.
It is recommended that the user must not exceed the 85% from each output, since all the bitrate
are variable according to their specific content.
4.2.7 - "IP streaming" page
In "IP streaming" section the user is able to setup the IP streamer of the device.
Figure No 10
Lemco
HCL-804CT manual v1.0
14
Advertisement
