Advertisement
The status section in (Figure No 7) provides a general idea to the user of the current payload
(according to the selected programs) comparing to the max. output payload.
It is recommended that the user must not exceed the 85% from each output, since all the bitrate
are variable according to their specific content.
Peak Detection mechanism
As shown in Figure No 7 there is a colored indicator of the peak detection mechanism, for each
output transport stream. This indicates if any overflow has occurred on modulator's output
bitrate with the following colors:
Green – No overflow occurred
Yellow – No overflow occurred but the input bitrate is close to the output bitrate
Red – Overflow occurred. The user must decrease the input bitrate
4.2.6 - "RF Output" page
In the "RF Output" page (Figure No 8) the user is able to setup the RF output settings of the
HCL-804CT.
Lemco
HCL-804CT manual v1.0
Figure No 7
12
Advertisement
