Control Element (Smartemp) - Webasto Air Top 2000 ST Installation Manual

Electrical Connections
8.5

Control Element (SmarTemp)

The Control Panel should be installed in a suitable location on a flat surface if possible in a visible area.
– Connect control panel to existing
connectors on heater-unit wiring harness
(see "Connections Diagrams Section")
– Use the drilling dimensions (fig. 33) to
lightly mark the two mounting holes.
– To route wire harness through the
mounting surface, drill a 22 mm hole.
Make sure to push harness through the
hole before installing terminals into
connector housing)
– Secure the SmarTemp Control using the
two supplied #4 screws.
– Follow the electrical pin-out fig. 34 to
install the supplied harness connector and
harness adapters.
– Apply any warning or caution stickers that
are supplied with the SmarTemp Control.
– Observe the installation / operating manual
supplied for proper menu setup.
NOTES:
– Always make sure there are no obstacles behind
the mounting location prior to drilling.
– Ensure good readability when selecting installation
location.
– Observe information on adhesive labels and
colored markings when connecting the control
element to vessels wiring harness.
Webasto Thermo & Comfort N.A., Inc.
Air Top 2000 ST - Air Top Evo 40/55
Figure 32. Control element (SmarTemp)
Figure 33. SmarTemp drilling dimensions
34 www.techwebasto.com