Subscribe to Our Youtube Channel
Related Manuals for Sentera Controls DRY-1-15-AT
Summary of Contents for Sentera Controls DRY-1-15-AT
- Page 1 ELECTRONIC FAN SPEED CONTROLLER, DIN RAIL MOUNTING Mounting and operating instructions...
-
Page 2: Table Of Contents
ELECTRONIC FAN SPEED CONTROLLER, DIN RAIL MOUNTING Table of contents SAFETY AND PRECAUTIONS PRODUCT DESCRIPTION ARTICLE CODES INTENDED AREA OF USE TECHNICAL DATA STANDARDS WIRING AND CONNECTIONS MOUNTING INSTRUCTIONS IN STEPS OPERATIONAL DIAGRAM TRANSPORT AND STORAGE TROUBLESHOOTING WARRANTY AND RESTRICTIONS MAINTENANCE MIW-DRY-EN-000 - 18 / 09 / 2024 2 - 7... -
Page 3: Safety And Precautions
ELECTRONIC FAN SPEED CONTROLLER, DIN RAIL MOUNTING SAFETY AND PRECAUTIONS Read all the information, the datasheet, Modbus map, mounting and operating instructions and study the wiring and connection diagram before working with the product. For personal and equipment safety, and for optimum product performance, make sure you entirely understand the contents before installing, using or maintaining this product. -
Page 4: Product Description
■ Unregulated output load (L1): 230 VAC / max. 0,5 A ■ Regulated output to motor / fan, U: ► max. load: 1,5 A for DRY-1-15-AT; ► max. load: 2,5 A for DRY-1-25-AT. ■ Speed control from minimum to maximum ■... -
Page 5: Wiring And Connections
ELECTRONIC FAN SPEED CONTROLLER, DIN RAIL MOUNTING ► EN 61000-6-2:2006 Electromagnetic compatibility (EMC) - Part 6-2: Generic standards - Immunity for industrial environments ► EN 60730-1:2011 Automatic electrical controls for household and similar use - Part 1: General requirements ■ RoHs Directive 2011/65/EU WIRING AND CONNECTIONS L L1 N N U... - Page 6 ELECTRONIC FAN SPEED CONTROLLER, DIN RAIL MOUNTING Fig. 1 DIN rail locking clip Locking clip Lock release Choose a proper DIN rail as you bear in mind the dimensions (please see Fig. 2 Mounting dimensions) of the unit and mount the controller, minding the correct position, shown on Fig.
-
Page 7: Operational Diagram
ELECTRONIC FAN SPEED CONTROLLER, DIN RAIL MOUNTING OPERATIONAL DIAGRAM Use a regular screwdriiver to adjust the desired output voltage from 100 VAC to 230 VAC via the integrated trimmer on the device. The factory preset setting of the voltage is 100 VAC. Turn the trimmer clockwise to set the maximum speed of the fan and counterwise to set the fan speed at minimum.
Need help?
Do you have a question about the DRY-1-15-AT and is the answer not in the manual?
Questions and answers