Bonex ECOS Instructions For Use Manual page 7

BONEX-SCOOTER
Instruction for use
5. Aftertreatment:
Rinse the scooter completely well after operating in saltwater!
After usage in saltwater remove the propeller and rinse the glide
sealing from the outside!
DO NOT ATTEMPT TO CLEAN GLIDE SEAL MECHANICALY!
Switch „OFF" scooter on main switch!
Check the inside of the scooter occasionally.
Remove Tube during charging operations!
Charge each battery separately (DISCOVERY series)!
6. Maintenance:
Clean occasionally and wipe the scooter backend with silicon spray!
Check Tube O-rings after 6 month and change them at least once a
year (long storage will cause deformation of the O-rings)!
Once a year grease the shaft of all switches (disassemble the knob)!
Once a year grease the O-rings of the slide sealing!
Once a year grease the O-rings of the shaft inside the nose!
(Lift up the pressure plate)
Exchange all O-rings every two to three years!
Occasionally check or exchange the zinc anode.
Please heed the advice for a smooth run of the scooter and a long joy over
your Bonex-Scooter! This is just a quick check. This does not show the
complete maintenance.
If desired, Bonex will do the service for you.
Version: 2016_08 Page 5