Scoter Trim - Bonex ECOS Instructions For Use Manual

BONEX-SCOOTER
Instruction for use
8.2 Scooter Trim:
For using our scooters in saltwater, please use the additional lead balance
weights as follows:
For determination of the needed quantity of lead, please put your scooter
into saltwater and put some of the big lead (thin and/or thick) on the front
of the tube. Only until the tube of the scooter is under water. For a slight
positive trim, the system handle should stay outside of the water.
Please repeat this with the back/bottom of the scooter – put here the small
lead onto the shroud. The main handle should stay half outside of
the water (as you can see in the attached picture).
Now you know the exact amount of lead to be added. Now take your
scooter out of the water, dry it, open the scooter and screw the big front
lead plates into the nose and the rear lead onto the motor bracket.
Please, keep attention, that the lead will only be added on top of the inside
existing lead.
For the assembling please use an Allen key with ball button, so as not to
damage the screws.
For military use, it might be necessary to trim the scooter negative. In this
case, add more lead.
Version: 2016_08 Page 17