Charging The Battery - Bonex ECOS Instructions For Use Manual

BONEX-SCOOTER
Instruction for use

11. Charging the battery

Only use the Bonex-Scooter charger to charge the battery!
Always remove the tube during charging!
Disconnect the battery from the battery plug with the plug system.
Connect the charger to the power supply before you switch it on (switch at
backside) LED_1 red (Voltage ready); LED_2 green (Charger ready to
charge), now connect the charger plug with battery connector. LED_2 light
changes green to red and indicates start of charging. Charging procedure
is finished when LED_2 lights green.
The connection can be operated in Europe on the 230V DC mains or in
other countries with 110V.
The charging time may increase under such conditions.
Standard-Charger for ECOS models – 110 / 230V charger switches
automatically
The charger has 1 diode (red / green).
The diode lights „RED" when charging starts.
Afterwards the diode changes to „GREEN". Charging is complete.
QCS Quick-Charger – 110 / 230V
The charger has 2 diodes (red and red / green).
1. diode lights „RED" when charger is connected to the power supply and /
or charger is connected to battery.
2. diode lights „RED" when the main switch of the charger is on and
charger operates.
2. diode lights „GREEN" when charging is complete.
During the charging process the vent in the charger will operate all time.
Do not cover the charger during the charging process!
The charger serves exclusively for charging lithium-ion batteries!
Charger cannot be used to charge a lead gel, NiCd or NiMh battery!
Never leave the scooter unattended during charging!
In the event of excessive heating of the battery pull out the main plug,
disconnect battery from charger and contact the manufacturer!
Version: 2016_08 Page 26