Troubleshooting - Bonex ECOS Instructions For Use Manual

BONEX-SCOOTER
Instruction for use

14. Troubleshooting

In case of malfunctions or failure, the table below presents a list of the most
typical problems.
Fault
Scooter does not
operate
Speed governor
does not work
Emergency drive
switch does not work
Scooter immediately
starts after switching
main switch „ON"
Drive immediately
stops again after
starting
Charger diodes does
not light
Inrush of water
Version: 2016_08
Cause of failure
>Battery plug not connected
>Battery empty
>Main switch „OFF"
>Fuse defective
>Reed sensor defective
>Main switch defective
>Cable break
>Motor defective
>Magnet of drive switch is missing
>Speed governor defective
>Emergency drive switch activated
>Reed sensor defective
>Magnet removed from round piece
>Emergency drive switch activated
>Drive switch (Trigger) pressed
>Torque control
>Temperature controlg
>Battery voltage too low
>No current at socket
>Charging plug not connected
>Charger defective
>Battery defective
>O-rings leakage
>Sliding ring seal leakage
>Broken housing
Remedy
>Connect
>Recharge battery
>Switch main switch to „ON"
>Replace fuse
>Replace reed sensor
>Replace main switch unit
>Replace cable / switch unit
>Return to manufacturer
>Glue a new magnet
>Replace speed governor unit
>Deactivate emergency switch
>Replace reed sensor
>Stick magnet in round piece
>Deactivate emergency switch
>Release drive switch
>Switch „OFF" and „ON"
>Switch „OFF" and „ON"
>Recharge battery
>Choose other socket
>Insert plug
>Return to manufacturer
>Return to manufacturer
>Replace O-ring
>Replace sliding ring seal
>Return to manufacturer
Page 35