Brief Instructions For Bonex-Scooter - Bonex ECOS Instructions For Use Manual

BONEX-SCOOTER
Instruction for use

2. Brief instructions for Bonex-Scooter

1. Read the manual carefully before operating the device!
2. Storage:
Main switch „OFF" (otherwise total damage of battery is possible!)
Place scooter with "Shroud" down on flat ground or store it in the
transport box with the label "TOP" on the top.
Place scooter in shadow (sun heats up the interior)!
Remove Tube O-rings before prolonged storage!
Store the battery in partially charged conditions!
(Recharge battery immediately before intended usage)
3. Transport (with parcel service etc.):
Remove battery plug and put safety cap on battery connector!
Check the reliable fit of the battery inside the scooter!
Transport the scooter only in the original transport box or in the
additional transport bag fitted in a carton with foam!
4. Starting up:
Charge battery (or check status with capacitance meter)!
Check the battery connector cable for proper connection to battery!
ATTENTION AT DISCOVERY SERIES THERE ARE 2 BATTERIES!
BOTH BATTERIES HAS TO BE CHARGED AND CONNECTED!
Remove all dirt (hair, dust, greenery, etc.) from the seal seats!
Lightly grease all Tube O-rings!
Lightly grease Tube at both seal seats!
For saltwater use, mount the salt water lead on top of the basic lead!
Mount the Tube with the „Bottom-Sticker" in direction to the shroud
and align it towards the zinc anode!
Wrong mounting of Tube can cause leakage!
Don't place the scooter in direct sun (Battery can be damaged)!
Version: 2016_08 Page 4