Controls To Perform Before Starting Up - Bonex ECOS Instructions For Use Manual

BONEX-SCOOTER
Instruction for use

8.3 Controls to perform before starting up

Ensure that the power pack is sitting tight and connect the battery plug. The
battery plug only fits in one position so that the union nut also engages.
Screw the union nut of the battery plug to the end of its thread so that the
plug is also tight.
Make sure that the cable is laid without twisting and in one loop upwards.
Look at Illustration 7b (Scooter top side) page 11.
(ATTENTION: DISCOVERY series owns 2 battery connectors)
Make sure that all balancing weights are firmly in place and no loose parts
fall around in the scooter. Check visually that all the cable plugs are tight
and the cables are not damaged.
Check the firm fitting of the battery pack(s).
Grease the sealing rings and the inside edge of the Tube lightly with
silicone grease. Push the Tube downwards („Bottom-Sticker" must be
aligned towards the zinc anode) until it came in contact to the housing.
Please act in same procedure with scooter nose. In the nose there are two
center poles to be aligned to the traverse. Please note that the scooter
housing cannot be closed correctly if the center poles in the nose are not
aligned in correct position and the tube isn´t assembled in the right
direction. While mounting the nose the System handle has to be on the
opposite side of the zinc anode!
Hold the silver eccentric lever up when setting down the nose and push the
nose in up to the mechanical stop.
To close the nose, the red dot on the pressure plate must be aligned to a
position at 3 a clock or a position at 9 a clock. During this procedure the
second red dot remains at 6 a clock. Push the silver eccentric lever
downwards until it gets in contact to the pressure plate. Now turn the silver
eccentric lever to the right or the left side for 90°, until the two red dots are
aligned again. At least force the silver eccentric lever downwards until it
becomes contact to the nose surface.
NEVER USE EXTREME FORCE TO CLOSE THE SCOOTER
If necessary control complete mounting procedure!
At the delivery the scooter is trimmed a little bit positive (approx. 50gr). If
you assemble additional gear at the scooter, it could become necessary to
trim it again. Also you have to trim the scooter again if you intend to use it
in saltwater. For this option you can add some additional balance weights
inside the scooter nose and in the back tail underneath the screws. Optimal
trim is reached if front system handle is approx. 25mm outside water and
round handle at tail is approx. 15mm outside water surface. Please take
care that the flattened lead plate inside the nose are assembled at last!
Version: 2016_08 Page 18