Transport And Storage - Bonex ECOS Instructions For Use Manual

BONEX-SCOOTER
Instruction for use

10. Transport and storage

The battery should be disconnected from the scooter at the plug for storage
and transport. This also prevents the scooter from being accidentally
switched on.
This is absolutely essential for transport by courier or parcel service.
Always put the box straight up if stored or transport it in a transportation
box. The label TOP must stay at the top or rather the scooter should stand
inside the box on his shroud.
A transport backpack is available as an option for safe transport. The
scooter is centred at the front and rear and bedded in foam padding. It is
therefore optimally protected against knocks and bumps.
If extreme external influences are to be feared, the battery and the charger
should be removed and stored separately.
A carton should be used for additional outer protection if the scooter is
transported by a parcel service or courier.
Please observe the valid regulations regarding the transport.
You should dry the scooter thoroughly before opening after use. Open the
scooter after every dive to remove dirt and any moisture which may have
penetrated. Water can lead to corrosion spots on aluminium surfaces which
can be avoided if they are removed immediately. Keep your scooter in a
safe, dry place. It should be stood on the jet. The silver eccentric lever
should be left in the open position during longer periods of storage.
The battery should be tested after long breaks. Pay attention to formation
of corrosion or oxidation on the power pack. A white coating may be an
indication of defective cells. If the power pack does not work perfectly after
restarting, it must be sent to the manufacturer for inspection.
Store the battery at a save place at approx. 15°C – 20°C.
If you intend to store the scooter for a prolonged time (> 4 weeks), store
the battery in partially charged conditions! Recharge battery immediately
before intended usage. You should also remove the Tube O-rings before
prolonged storage. Store the O-rings in a bag inside of the scooter.
Attention: Keep in mind to reinstate the O-rings before intended usage!
Risk of damage due to inrush of water!
Version: 2016_08 Page 25