Bonex ECOS Instructions For Use Manual page 21

BONEX-SCOOTER
Instruction for use
Round handle Drive switch (Trigger)
Abb.: 8a
Emergency drive switch
(NOT at ECOS)
The Bonex-Scooter is now ready for operation.
To check the correct function, place the scooter on a flat surface and
secure it against accidentally rolling away. Switch the main switch to „ON".
to get scooter ready for operation. In models with two separate battery
packs (DISCOVERY series) the respective pack can be activated by
turning the main switch in position 1 | 2. The position in the middle is means
„OFF". The propeller starts to turn when you activate the drive switch. The
revs of the prop and therefore the pulling speed can be varied by adjusting
the speed governor. When the mark on the governor switch is at 12 a clock
you reach a pull speed of approx. 60%. The main switch of the ECOS
model also functions as a five speed step switch. After releasing the drive
switch press the emergency drive switch by pushing the round piece to its
outer rest position. When performing this way the propeller turns at a
constant speed. Now push the emergency drive switch back to its initial
position. The model ECOS is not equipped with this option. You can
choose the speed on the central knob in five positions.
The scooter has now been tested again for all functions and is ready to go.
Schalten Sie den Hauptschalter wieder in die Stellung „OFF".
In case off malfunctions or failure occur please proceed as described in
chapter (14. Troubleshooting) at page 355.
Version: 2016_08
Speed governor
(NOT at ECOS)
Main switch
(ECOS with 5 speed steps)
Page 19