Audio Input Level Setting (Input Level); Low-Cut Filter Setting (Lcf); Power-Saving Setting (Power Save); Power Setting (+48V) - Sony DWR-S02DN Operating Instructions Manual

Audio Input Level Setting
When the input of the transmitter is set to MIC, the value
of the attenuator can be changed.
The attenuator values that can be selected depend on the
transmitter function.
Low-cut Filter Setting
The low-cut filter setting of the transmitter can be changed.
Note
The frequency selection depends on the transmitter
function.
Power-saving Setting
To conserve power, this setting allows you to change the
transmitter to sleep mode using the wireless remote control
function.
Note
When the transmitter changes to sleep mode, transmission
of the RF audio signal and metadata is stopped. For this
reason, "NO DATA" appears for all items in the TX1/2
menu, except for "SLEEP" in the POWER SAVE
indication.
+48V Power Setting
Turns the +48V on the transmitter on or off.
Note
This function may not be supported depending on the
transmitter.
Cross Remote Setting
OFF: Stops the wireless remote control function.
ON: Starts the wireless remote control function with the
previously paired receiver.
PAIRING: Executes a new pairing.
For details, see "Using the Cross Remote" on page 16.
Audio codec mode setting
(CODEC MODE)
Set the audio codec mode.
Note
This function may not be supported depending on the
transmitter.
(INPUT LEVEL)
(LCF)
(POWER SAVE)
(+48V)
(RF REMOTE)
18