Preheating; Set Date And Time; Figure 15 - Sc1000 Preheat; Figure 16 - Sc1000 Number Of Hours - Valeo SC1000 IVECO Operating Instructions Manual

BUS BODY ELECTRONICS

2.5 Preheating

Note
Programming, operating the heater and setting up the
timer of the heater is the responsibility of the driver.
He must ensure that at the start time the circumstances
and the parking situation are suitable.
For security reasons it is only possible to program the
timer for the same and the next working day. The Start
time delay for Monday is already possible on Friday.
To activate the preheating function the engine must be
off.
The pre-heating function will only be executed if no low
voltage (<22V) is present. Otherwise, the function is au-
tomatically terminated after 10 seconds.

2.5.1 Set date and time

Note
Day and time are set in the following order:
hours – minutes – day of the week.
The position to be set is flashing.
Press button (Fig.5, No.8) for 3 second.
➔ "Pre" appears on the display (Fig. 15).
Press button or
➔ "hour" appears on the screen (Fig. 17) and the hour
digits flash.
Press button to increase the number of hours (0-23 h).
Press button to decrease the number of hours (0-23 h).
Press button to confirm value.
➔ Minute digits flash.
Now proceed exactly as described for setting the number of
hours to set the number of minutes.
➔ Now the week days are displayed (Fig. 18).
(Fig.5, No.12) once.

Figure 15 - SC1000 Preheat

Figure 16 - SC1000 ti-A

Figure 16 - SC1000 Number of Hours

Figure 17 - SC1000 Week Day

15