Maintenance - WAGNER AG-08 Owner's Manual

Cleanup
Maintaining a clean gun is important to ensure trouble-free operation. Flush the gun after each use
and store in a dry location. Do not leave the gun or any of its parts in water or solvents.
Special cleanup instructions for use with
flammable solvents:
• Always flush spray gun preferably outside and at least one hose length from spray pump.
• If collecting flushed solvents in a one gallon metal container, place it into an empty five gallon
container, then flush solvents.
• Area must be free of flammable vapors.
• Follow all cleanup instructions.
The sprayer, hose, and gun should be cleaned thoroughly after daily use. Failure to
do so permits material to cake, seriously affecting the performance of the unit.
Attention
Always spray at minimum pressure with the tip and tip guard
removed when using mineral spirits or any other solvent to clean
the sprayer, hose, or gun. Static electricity buildup may result in a
fire or explosion in the presence of flammable vapors. Hold the
gun firmly against a metal container while flushing.

Maintenance

Follow all safety precautions as described
in the Safety Precautions section of this
manual before proceeding.
i
Refer to the Parts List section in this manual for part identification.
Replacing/Servicing the Seal Assembly
If your spray gun leaks or spits at the tip when you release the trigger, the needle or seat is worn,
damaged, or dirty and must be replaced or cleaned.
Never attempt to perform maintenance
on the spray gun without first performing
the "Pressure Relief Procedure."
1. Disconnect the fluid hose from the gun.
2. Remove the tip and tip guard.
3. With the trigger depressed, remove the diffuser from the front of the gun.
4. Remove the lock nut, rear housing, and retractor pins from the rear of the gun head.
5. Remove the seal assembly from the front of the gun head by pushing or gently tapping at the
back of the seal assembly.
6. Soak the removed parts in the appropriate solvent and wipe clean.
7. Inspect the parts for wear or damage and use new parts during reassembly of the gun, when
necessary.
i
Lubricate all packings and moving parts before reassembly with a lithium-based
grease.
8. Install the seal assembly into the front of the gun head.
14
GB
AG-08