Parts List - WAGNER AG-08 Owner's Manual

9. Install the retractor pins into the rear of the gun head. Slide the rear housing onto the
retractor pins and secure in position with the lock nut.
10. WIth the trigger depressed, install the diffuser into the front of the gun head and tighten
securely with a wrench.
11. Perform the "Adjusting the Seal Assembly" procedure described below.
Adjusting the Seal Assembly
Proper adjustment of the seal assembly is
essential to ensure positive shut-off when the
trigger is released.
1. Tighten the lock nut until the rear housing is flush against the gun head.
2. Unscrew the lock nut 3/4 of a turn.
To check the adjustment of the seal assembly:
i
1. Move the gun trigger lock to the locked position.
2. Pull the trigger.
With the trigger lock engaged, there should be 1/32" of movement between
the lock nut and the rear housing while pulling the trigger.
Replacing/Removing the Filter
1. Pull the bottom of the trigger guard forward so that it comes loose from the handle assembly.
2. Loosen and remove the handle assembly from the gun head.
3. Pull the old filter out of the gun head.
4. Slide the new filter, tapered end first, into the
gun head.
5. Place the handle seal into the gun head with
the flat side of the seal toward the gun head.
6. Thread the handle assembly into the gun
head until secure.
7. Snap the trigger guard back onto the handle
assembly.
Filter Chart
Parts list, page 66
AG-08
Part Application
Number
0034383 Synthetic resin,
enamels, clean
varnishes, stains
azures
0043235 Base coat enamels,
primer enamels,
fillers, marking paints,
textured enamels
0034377 Emulsions,
latex paints,
acrylic paints
0089323 Filler paints,
large area surfaces
GB
Flat side of
handle seal
(toward gun head)
Filter
Type
Extrafine
Fine
Medium
Coarse
Bevelled side of
handle seal
(toward handle)
Color of
Filter
Body
red
yellow
white
green
15