Advertisement
ASSEMBLY INSTRUCTIONS
Step 2: Assembly of the main wing. Insert the carbon wing joining rod through the fuselage,
ensure it remains central. Slide on the wings just far enough so that you can connect the
aileron servo leads. Slide the wings the rest of the way making sure you feed the wires and
connectors back into the fuselage. The wings should slot into the grooves in the fuselage
wing roots and the strong magnets will hold them in place.
Step 1: Assembly of the nosewheel. Fit the nosewheel into
the nosewheel steering collet with the spring at the back.
Ensure the flat on the wire lines up with the M3 x 3mm
grub screw in the steering collet. Use a hex wrench to
tighten the grub screw.
Step 3: Main landing gear. Install the main landing
gear into the grooves on the main wings using the
2 x 8mm self tapping screws provided.
Step 4: Assembly of the vertical stabilizer. Connect
the rudder servo to the rudder extension lead. Fit
the vertical stabilizer into the slot at the rear of the
fuselage, carefully feed the servo connector down
inside the fuselage. Ensure the rear plywood
tongue engages securely with the flat on the
horizontal stabilizer joining rod, this stops the rod
twisting. Secure into place using the 2 x 10mm self
tapping screws provided.
2
Advertisement
