Control Locations And Operating Modes; Application Macros; Local Operating Elements; Local Control Panel - ABB ACS580MV Hardware Manual

For detailed information on the parameters for signal allocation, signal type selection,
signal inversion, scaling, and filtering, see:
•
ACS580MV primary control program firmware manual

Control locations and operating modes

The ACS580MV has two main control locations: external and local. The control location is
selected with the Loc/Rem key on the control panel or in the PC tool.
Refer to ACS580MV primary control program firmware

Application macros


Refer to ACS580MV primary control program firmware

Local operating elements

The local operating elements are located on the front door of the control compartment.

Local control panel


The control panel serves as the basic user interface for operating and monitoring the drive
when the local operating mode has been selected.
The control panel can be attached to or detached from the drive without having to switch
off the auxiliary power supply first.
Using the control panel, it is possible
•
to enter start-up data
•
to control the drive with a reference value, and start, stop and direction commands
•
to display actual values (3 values can be read simultaneously)
•
to display and adjust parameters
•
to display information on the most recent fault events
•
to display history graphs
•
to upload and download complete parameter sets.
The control panel has a status LED that indicates if there are any faults or warnings
present. The table below shows the meaning of the LED indications.
LED status Meaning
Green, Normal operation
continuous
Green, Data is transferred between the PC tool and drive through the
flickering USB connection of the control panel.
Green, Alarm pending
flashing
Red Drive in fault state.
For details on use and maintenance of the control panel refer to
control panels user's manual.
Control system and interfaces 43
manual.
manual.
ACS-AP-X assistant