Clock - Renault Kangoo 1998 Manual

CLOCK

Clock 1
The time is displayed when the
ignition is switched on.
Setting the clock
- Turn button 2 briefly to the right.
The hours display will flash.
Press button 2 briefly or hold it
down to change the hours display.
- Turn button 2 to the right again
briefly.
The tens flash on the minute
display.
To alter the minutes, press button
2 briefly or hold the button down.
1.78
- Turn button 1 to the right again
briefly.
The minute display flashes.
To adjust the minutes, press
button 1 briefly or hold the button
down.
- Finally, turn button 1 to the right
again to confirm that the adjusted
time is correct.
1
2
If the electrical supply is cut
(battery disconnected, supply
wire broken, etc.), the clock will
lose its time setting.
The clock must be reset.
We recommend that you do not
carry out these settings when
driving.
4
3
Clock 4
Setting the clock
With the ignition switched on and
the display set to total mileage
recorder and clock, press and hold
button 3, to access time setting
mode (the clock display flashes)
then release the button.
- Pressing and holding down button
3 allows you to scroll through the
hours and minutes quickly;
- pressing button 3 briefly allows
you to set the time minute by
minute.